if not accurate operation, is likely to arise the unnecessary accidents, to ensure that machinery and equipment are maintained in good condition and to ensure the safety of produce and reduce occupational safety and health hazards, using the Sand maker under a certain security can not be ignored, Shanghai Ming work suggestions:
 
1  start on , check the cavity observed eddy transfer gate is closed tightly;

2, check the direction of impeller rotation, to see the direction from the feed inlet. Scroll wheel should be counter-clockwise, or adjusted the electric wiring;
3, Sand maker must empty load started . when the Sand Making Machine is operating normally we can feeding, Sand and transportation equipment, the boot sequence is: → Discharge → Sand feeding, stop with the boot sequence in reverse order;
4, feed particles in strict accordance with designation requirements, prohibited materials into the Sand Maker more than delineated, to avoid clogging the impeller channel and the central feed tube, and strive to continuously feed .
5, when marker device stops moving, you should stop feeding in time;
6, Sand operation of the process, if excessive vibration and unusual noise, parking and checking should be immediately;
7,in Sand maker ‘s each working period,  add the lubricating oil in time.
Safety is very important, so in the operation to ensure safe of the equipment , protective measures, therefore the above seven requirements must be followed.

Correlation Information

• General troubles and solution of Jaw crusher Part 3
• how to install a jaw crusher
• jaw crusher can not crush
• hammer crusher general problems and solutions
• Advanced technology of sand production