After the Starting,there have the metal crash in the machine, even smoke and sparkin the feeding port
causes
1. Fall into the metal debris inside the machine
2. Hammer head and the strip gap is too near
3. Hammerhead oversized
4. Liner loose, bearing cap relaxation
methods to eliminate
1. pause and cleaning
2. To re-adjust
3. Replace the worn hammer head
4. Retighten

Speed slows down, production decreased
causes
1. Charging uniform
2. Belt slipping
3. Material too wet
4. Hammerhead serious wear one.
methods to eliminate
1. Stop feeding, to be operating normally after the feeding
2. Tensioning drive belt
3. To eliminate the blockage, drying wet material
4. Replace hammer

Vibration
causes
1. The basis of insufficient strength, ground screw loose
2. Hammerhead uneven wear, resulting in biased towards
methods to eliminate
1. To re-adjust the hammer weight, and balanced
2. Test

Bearing temperature
causes
1. Oil shortage
2. Bearing seal fails, the oil pollution
3. Bearing wear one.
methods to eliminate
1.Add oil
2. Cleaning sealed bearings, replace grease
3. Replace bearings

The size of thicker material
1. Hammerhead or lining and wear grate
2. Grate loose or broken one.
methods to eliminate
1. Update wear parts
2. To re-tighten or replace

Correlation Information

• General troubles and solution of Jaw crusher Part 3
• how to install a jaw crusher
• jaw crusher can not crush
• hammer crusher general problems and solutions
• Advanced technology of sand production
• How to maintain an impact crusher
• Artificial sand making
• hammer problems of hammer crusher