The main parts of the Cone Crusher’s eccentric shaft should to replaced or mend,if it is used :
1. the outer awl on the eccentric shaft has a wear 3mm
2. the distance between bush and the liner of the eccentric shaft surpass the orignal’s one times more,straight cover have defect,surpass the 1/3 length of the body.either of these problem ,change the straight bush.
3. distance between awl bush and the main shaft surpass one times than the original.
4. the big gearing has loss for 20%

liner assambly
                  specification
gap         900 1200            
Body frame’s lining(mm)  20.38 
distance between awl bush to top (mm)  3.2 0.3 
distance between awl bush to below (mm) 10 

Correlation Information

• General troubles and solution of Jaw crusher Part 3
• how to install a jaw crusher
• jaw crusher can not crush
• hammer crusher general problems and solutions
• Advanced technology of sand production
• How to maintain an impact crusher
• Artificial sand making
• hammer problems of hammer crusher